Replacing fluorescent tubes with LED T8: plug-and-play vs ballast bypass
Short answer: Check which type the LED tube is before you buy or install it. Type A (plug-and-play) runs on the fixture's existing fluorescent ballast, so the ballast must be compatible. Type B (ballast bypass, direct wire) is wired to line voltage with the ballast removed, which is a wiring change. Type C uses a separate LED driver. Some tubes are labeled for more than one type. The type is on the tube's label and in its product details.
Safety: Ballast-bypass conversion is electrical work. Turn off the breaker, follow the tube maker's wiring diagram and local code, and use a licensed electrician if you are not qualified.
Before you swap
- Read the tube's type. Look for Type A, Type B, Type C or a combined type on the label or spec sheet.
- Type A: check the ballast. Plug-and-play tubes list the ballasts they work with. If the ballast is not listed, or it fails later, the tube will not light.
- Type B: plan the rewiring. The ballast is removed and the sockets are wired to line voltage as the tube maker's diagram shows (single-ended or double-ended). Fixtures converted this way should be labeled so nobody puts a fluorescent tube back in.
- Match the length and base. T8 tubes are 1 inch in diameter with G13 bi-pin ends; common lengths are 2 and 4 feet.
- Turn off the power. Switch off the circuit at the breaker before opening a fixture.
LED tubes and fixtures
- CONVEX | LED T8 Tube (157101) — $24.99
- CONVEX | LED T8 Tube (157101) — $19.99
- ZELL | LED T8 Tube (156250) — $24.99
- ZELL | LED T8 Tube (156250) — $19.99
- Fantik | LED Center Basket Troffer (157104) — $60.99
- BROOKS | LED Linkable Strip Fixture — $54.99
Common questions
Can I put an LED tube in any fluorescent fixture?
Only if the tube's type matches the fixture: Type A needs a compatible ballast, Type B needs the ballast removed and the fixture rewired, Type C needs its own driver.
Why won't my plug-and-play LED tube light up?
The ballast may not be on the tube's compatibility list, or the ballast may have failed.
What does T8 mean?
The T number is the tube diameter in eighths of an inch, so a T8 tube is 1 inch across.
Related categories: LED Light Bulbs. General information only; follow the equipment maker's instructions and local codes. Updated 2026-11-14.