MadMax Trade Supply

Home › Guides

How to change a whole-house water filter cartridge

Short answer: Shut off the water to the filter (or put it in bypass), press the housing's pressure-release button or open a faucet to drop the pressure, unscrew the housing bowl, swap the cartridge for one with the same part number or size, check and re-seat the O-ring, hand-tighten the bowl, then turn the water back on slowly and check for leaks. Follow your housing maker's instructions where they differ.

Safety: Never open a housing that is still under pressure. If the bowl will not budge, see our guide on stuck or leaking housings instead of forcing it.

Step by step

  1. Find the replacement. Read the part number on the old cartridge or its end cap, or measure it: standard cartridges are about 2.5 inches across and Big Blue (BB) cartridges about 4.5 inches, in 10- or 20-inch lengths. The cartridge must match the housing.
  2. Shut off the water. Close the valve before the filter, and the one after it if you have one, or turn the bypass valve to bypass.
  3. Release the pressure. Press the red pressure-release button on top of the housing if it has one, or open a cold faucet downstream until the flow stops.
  4. Remove the bowl. Put a bucket underneath and unscrew the bowl with the housing wrench. Turn it the way the arrows on the housing show.
  5. Swap the cartridge. Pull out the old cartridge, rinse the bowl, and center the new cartridge on the standpipe in the bowl and the post in the cap.
  6. Check the O-ring. Wipe the O-ring and its groove. Replace it if it is cracked, flattened or stretched. Many housing makers suggest a thin coat of food-grade silicone lubricant.
  7. Tighten by hand. Screw the bowl back on hand-tight, plus the small extra turn the maker allows. Over-tightening is a common cause of stuck bowls and leaks.
  8. Turn the water on slowly. Open the inlet slowly with a faucet open to let the air out, then check the bowl and cap for drips. Some carbon cartridges need a few minutes of flushing; follow the cartridge maker's instructions.

Whole-house replacement cartridges

Common questions

Which way does the filter housing unscrew?

Most housings show arrows on the cap or bowl. Facing the bottom of the bowl, most loosen counterclockwise, but follow the arrows on yours.

Can I put a 20-inch cartridge in a 10-inch housing?

No. The length and the diameter both have to match the housing: 10-inch cartridges go in 10-inch housings, 20-inch in 20-inch, and Big Blue cartridges only in Big Blue housings.

Why is there air in my water after a filter change?

Air trapped in the housing comes out at the faucets for a short time. Open a faucet slowly after turning the water back on until the flow is steady.

Shop water filter cartridges Standard vs Big Blue cartridges Sediment vs carbon filters Housing stuck or leaking?

Related categories: Under-Sink, RO & Whole-House Filters. General information only; follow the equipment maker's instructions and local codes. Updated 2026-11-14.